1 |
× |
Arduino Pro Mini, 5V/16MHz
The Brain. https://www.sparkfun.com/products/11113
|
1 |
× |
FTDI Basic Breakout Board, 5V
Provides power, firmware updates, and serial communication with a PC. https://www.sparkfun.com/products/9716
|
1 |
× |
SN75176B Differential Bus Transceiver
Converts the +5V / 0V output from the Arduino to a +5V / -5V differential signal for DMX. http://www.hobbyengineering.com/H1692.html
|
1 |
× |
Audio jack, 2.5mm panel mount
For communicating with the calculator. http://www.vetco.net/catalog/product_info.php?products_id=6830
|
1 |
× |
XLR female jack, 5-pin
For the DMX output. http://www.ebay.com/itm/1pc-XLR-5-Pin-Lock-Chassis-Female-Jack-DMX-Intercom-X5F-/300552931358
|
1 |
× |
Aluminum enclosure, 115mm x 60mm x 31mm
https://www.sparkfun.com/products/11735
|
1 |
× |
Protoboard, 3" x 2"
https://www.sparkfun.com/products/8815
|
1 |
× |
TI-84 Plus Silver Edition
Duh.
|
1 |
× |
TI Data Cable
For communicating between the calculator and the Arduino. https://epsstore.ti.com/OA_HTML/ibeCCtpItmDspRte.jsp?section=10431&item=36626&sitex=10023:22372:US
|
6 |
× |
Right angle male headers
Comes in a pack of 40. 6 are needed. https://www.sparkfun.com/products/553
|
26 |
× |
Straight male headers
Comes in a pack of 40. 26 are needed. https://www.sparkfun.com/products/116
|
2 |
× |
Female headers
Comes in a pack of 40. 2 are needed. Be aware that these are difficult to break apart from each other, and you will lose a header with every break.https://www.sparkfun.com/products/115
|
1 |
× |
Red LED, 5mm
Blinkenlights. https://www.sparkfun.com/products/9590
|
1 |
× |
LED holder, 5mm
I used this plastic one, but the chrome one from Sparkfun looks like it would be cooler. https://www.sparkfun.com/products/11840
|
1 |
× |
Resistor, 330 ohm
For the LED. https://www.sparkfun.com/products/8377
|
5 |
× |
Plastic standoffs, 4-40, 3/8"
Comes in packs of 10, but you only need 5. https://www.sparkfun.com/products/10461
|
5 |
× |
Screws, 4-40, 1/4"
Comes in packs of 10, but you only need 5. https://www.sparkfun.com/products/10453
|
2 |
× |
Nuts and bolts for XLR jack
I apologize, but I don't know enough about bolts to figure out the sizing. I just had them laying around and they worked perfectly.
|
2 |
× |
Male-to-female jumper cables
You probably have these lying around somewhere.
|