0%

0%

Brankly

I like to build random stuff

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

This user joined on 10/14/2020.

My Projects

Scary sounds included and foot-operated. Halloween Candy Dispenser that meets all social distancing requirements.

Automatic Halloween Candy Dispenser

Projects I Like & Follow

Hackaday Prize 2019

This wind-up car gift card is fully 3D-printable and is the ideal present for your friends and family.

Fully 3D-printable wind-up car gift card

Takes 3D surface scans at close range. It is simple to construct as it uses off the shelf hardware and software.

3D scanner

Hackaday Prize 2019

MIDI electronic portable practice hurdy-gurdy: It's always in tune.

The Digi-Gurdy

How to design your own HAT module including ID EEPROM.

Designing a Raspberry Pi HAT

Stepper motor driven laser projector capable of two dimensional scanning, blanking, automatic laser homing, and wireless bluetooth control.

Laser Projector V1

StanleyProjects

Hackaday Prize 2019

Small magic pcb for moving miniature cars, trains or satellites :-)

Ant highway - linear motor for micro cars

Use your Wemos motor shield with steppers motors I2C custom slave interface

WEMOS Motor Shield firmware for steppers (I2C)

A HAT to easily interface a Raspberry Pi with a KNX bus.

KNX Raspberry Pi HAT

Hackaday Prize 2019

This is a self balancing robot created by star wars fan, with autonomous behavior, FPV and remote control modes

Droid Trooper

The 2017 Hackaday Prize

Automate the button-pressing activity on a 433.92Mhz Gate remote controller, for the purpose of tests and measurement

Arduino-controlled Gate remote control

Zakhar is a robotics UX project. The main aim is to decrease the anxiety of users interacting with a robot.

Zakhar the Robot

Andrei Gramakov

Easy to use Arduino Uno Shield to support your rockets from the ground!

WOOF ROCKET LAUNCH COMPUTER V4

Canine-Rocket-Technologies

Hackaday Prize 2019

Omnidirectional 3D printer for... Houses?

Omniprinter - #Swarm 'Large Scale 3D Printing'

I'm attempting to recycle my household plastic into usable 3D printer filament

Recycling Household Plastic for 3D printing

Hackaday Prize 2020

The New Dexterity Low-Cost Robotic Airship for Education and Research

A Helium-Based, Affordable Robotic Airship

A project to understand and repurpose a low cost night vision IP camera.

iNite Night Vision Camera Reverse Engineering

An excellent project for location tracking involving a Ublox sensor and an Arduino, which can be used for many portable devices.

Arduino Ublox Neo-7N GPS Module Project

Our project is a garage door which operate using an arduino hardware and software

Garage Door 2020

Mateusz Grzebyk

View all

Bits