Hack Chat Transcript, Part 2

A event log for Soft Robotics Hack Chat

Robotics doesn't have to be hard

Dan MaloneyDan Maloney 10/27/2021 at 20:040 Comments

Ali Shtarbanov12:54 PM
@kjansky1 Here is one example of what you just mentioned

Ali Shtarbanov12:56 PM
@CocaKolev I also can't think of any right now

Inne12:59 PM
Is there a rule of thumb how large air cavities should be in pneumatic silicone actuators??

Ali Shtarbanov12:59 PM
Someone asked about piezo pumps. I never used those due to their high cost. But another big limitation with them is the very low flow rate.

Inne1:00 PM
Ok so not as awesome yet. Glad it saved me 350 dollars (for now ;) )

Dan Maloney1:00 PM
We're at the end of our allotted hour, so we'll have to wrap it up and let Ali get back to work. I just want to say a big thanks to him for spending time with us today, and to everyone for the great discussion. But feel free to keep the discussion going -- the Hack Chat is always open!

Ali Shtarbanov1:00 PM
You are welcome :)

kjansky11:01 PM
Best of luck in your work.

Ali Shtarbanov1:01 PM
Thank you! And if you have any questions, feel free to message me on any of the platforms I am on.

Inne1:02 PM
Thanks @Ali Shtarbanov I will check out

CocaKolev1:02 PM
Thanks @Ali Shtarbanov !