0%

0%

roman

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

This user joined on 06/16/2014.

Projects I Like & Follow

The 2017 Hackaday Prize

Pi Zero-based open-source mobile phone (that you can assemble for 50$ in parts)

ZeroPhone - a Raspberry Pi smartphone

Follow this project to learn how to use FPGAs and incorporate them into your projects.

The Hobbyists Guide to FPGAs

luke-valenty Luke Valenty

The 2017 Hackaday Prize

HeartyPatch is a fully open-source, IoT connected, BLE enabled heart-rate variability & ECG patch with great accuracy

HeartyPatch: A single-lead ECG-HR patch with ESP32

ashwin-k-whitchurch Ashwin K Whitchurch

HOW TO INSTALL A DNA READER AT HOME

DIY DNA SEQUENCER

alexander-sokolov Alexander Sokolov

The 2018 Hackaday Prize

Itsy-chipsy is a chip platform that enables a multi-block service like-oshpark capable to offer area for your own chip, for as low as $100.

Itsy-Chipsy: Make your own $100 chip

Simple FPGA based PCB to capture thermal images from a FLIR Boson camera on to a microSD.

Boson Frame Grabber

greg-davill greg davill

ice40 FPGA based custom board to control eink display

FPGA eink controller

The 2017 Hackaday Prize

This project describes the use of Raspberry Pi as an IoT connected vital signs monitor. The HealthyPi HAT for Raspberry Pi used.

Connected Health: Open source IoT patient monitor

ashwin-k-whitchurch Ashwin K Whitchurch

From raw RF samples of the GPS L1 C/A signal to a position fix, in a completely open fashion

Full Stack GPS Receiver

Mike "Hamster" Field

The 2017 Hackaday Prize

Low-cost, open-source FPGA boards in a tiny form factor with built-in USB, SPI flash, LDO, and MEMS clock.

TinyFPGA B-Series

luke-valenty Luke Valenty

Look Ma, no microcontroller

Breadboard VGA from TTL and EEPROM

marcel-van-kervinck Marcel van Kervinck

The 2017 Hackaday Prize

Could a digital device to analyze the statistics of the magnitude and 3-D origins of seismic noise predict some local earthquakes?

Device for Seismic Noise Analysis

michael-doody Michael Doody

Full blown RTOS written in Thumb ARM assembly language to fit in 1024 bytes

M0S - CortexM0 RTOS in 1024 bytes

The 2018 Hackaday Prize

Low Power Temperature/Humidity Monitoring

Gecko Node - Wireless Low Power Sensor

Tiny board with a BIG FPGA. SD card, 64mbit DDR RAM, ECP5 FPGA, 64mbit flash, and micro USB. Do more with up to 45k LUTs.

TinyFPGA E-Series

luke-valenty Luke Valenty

A credit card size Wireless Temperature & Humidity Node power by CR2032 Coin Cell

Wireless Temperature & Humidity Card

DIY 2,5" x 2,5" NaI(Tl) gamma spectroscopy probe

2,5" x 2,5" NaI(Tl) gamma spectroscopy probe

The 2017 Hackaday Prize

We have 4 Resistors, 4 Capacitors and 1 FPGA to make RADIO Receiver.

4R4C - FPGA Radio Challenge

antti-lukats Antti Lukats

View all

Bits

Radu Motisan wrote 07/12/2017 at 21:27

Thanks for the follow. You know what this is all about, right?

You can support this effort directly, by making your own KIT1 units or ordering a complete unit on https://www.uradmonitor.com/join-the-network/

Are you sure? yes | no

Tom Stiles wrote 08/21/2016 at 19:39

Thank you for following my project.

Are you sure? yes | no

Eric Hertz wrote 08/17/2016 at 05:13

Howdy! Thanks for the follow!

Are you sure? yes | no