0%

0%

Carlos Noguera

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

This user joined on 01/05/2017.

Projects I Like & Follow

IP over 430MHz Ham Radio, up to 500kbps, 20W RF. Extension for HSMM-Hamnet-AREDN. 100% open-source.

NPR New Packet Radio

Hackaday Prize 2019

Small and powerfull controlling unit powerd from USB-C-PD

USB-C-PD Soldering Pen for Weller RT Tips

Augmented Reality glasses using modified lowcost Android phones

Less than $100, high FOV, mobile AR glasses

Use a CC2531 USB Stick as a ZigBee Concentrator to replace your Philips HUE, Osram Lightify, Xiaomi/Aqara Hub, IKEA tradfri, etc. gateway.

ZigBee CC2531 smart home USB adapter

Hackaday Prize 2019

A wireless telecommunications device, based on LoRa technology, that receives and displays alphanumeric messages.

LoRaNicator

e-ink, BLE enabled 'smart' watch with PCB wristband

Schmartwatch

Notes about making a home made base for dual FX-951 soldering tips.

Home made, DUAL Hakko FX-951 station

lion mclionhead

Driving controller-less graphics LCD with Arduino

Arduino CLGLCD

Based on Tiny030 design

Building a 68030 computer in 5 stages

A cartridge for the SNES (Super Famicom) that uses the built-in wavetable chip to finally turn the console into a synthesizer!

SNES DRONE

Hackaday Prize 2019

An USB super speed Type C to Type A adapter which can extract the USB PD signal of the Type C port and use it e.g. for charging.

USB 3.1 Type C to Type A Adapter with PD

The Retevis RT40 is a licence-free digital two-way handheld radio with lots of unused potential!

Retevis RT40 Reverse Engineering & Extension

Want a laptop but don't like the choices? Why not build your own!

Open Source Laptop

Hackaday Prize 2019

Defining and implementing a bus protocol that is built around low-cost FPGAs to enable modular and affordable control and DAQ systems.

FBus: Open FPGA Realtime Bus

Custom-built general purpose, programmable, 6502-based computer and operating system.

Vectron 64

Create a fiber optic light illuminator for the 3D printed microscope v3

PCB inspection microscope

Designing an IoT device to monitor and report the fill level of bins for holding recyclable discards of various kinds.

Bin Level Monitoring

Soldering in 16GB of RAM. Easy or buy a new Mac after the attempt? ;)

Macbook Pro RAM upgrade

View all

Bits

Kris Winer wrote 6 days ago

Thanks for following my Bin Level Monitoring project!

Are you sure? yes | no

Asher Gomez wrote 12/20/2018 at 18:39

Thanks for following #Open Source Laptop!

Are you sure? yes | no

Patrick Van Oosterwijck wrote 08/31/2018 at 20:57

Thanks for following my #wESP32: Wired ESP32 with Ethernet and PoE project Carlos!

Are you sure? yes | no

Kris Winer wrote 07/09/2018 at 05:37

Thanks for following my SensorTile project!

Are you sure? yes | no

Laetitia BEL wrote 04/02/2018 at 13:40

∩༼˵☯‿☯˵༽つ¤=[]:::::> Thank you! for following the droni!

Are you sure? yes | no