Close

Chip-scale Arduino

knvdKn/vD wrote 08/19/2016 at 13:06 • 1 min read • Like

An old project of mine. Some two years ago I made this design which was part of the product range of my old company. It is a full Uno plus some extras fit on the very much favoured by me PLCC-68 format (roughly 1"x1").

Banguino is available from my Tindie store: https://www.tindie.com/products/KnivD/banguino-module/

Just like my newer Configum module it fits into a PLCC68 socket. In addition to the standard Uno it offers an additional 10-bit I/O port, micro-SD slot on board, USB connection, power supply, and pin-compatibility with all other modules (follows my own DTX2 standard pinout as described here several years ago: http://dimitech.com/downloads/an0003.pdf).


Like

Discussions

K.C. Lee wrote 08/19/2016 at 15:55 point

Saw this idea a long time ago for some Japanese FPGA modules.
This is much lower profile than the usual 0.1" headers.  If the secondary side is non-populated, then the module can be directly SMT which make it best of both worlds.  Hope more modules do this.

  Are you sure? yes | no

Yann Guidon / YGDES wrote 08/19/2016 at 14:58 point

Very nice !

  Are you sure? yes | no

deʃhipu wrote 08/19/2016 at 14:55 point

That is a very neat and clean layout!

  Are you sure? yes | no