Close

DIY 2020 5 series 3D Printer Build UK

rx-hmpRX HMP wrote 05/05/2017 at 12:50 • 3 min read • Like

Not sure what shape I am going with I wanted to ration bars for mini mill and a 3d printer or 2 3d printers.

Please advise if there is a solid way as this is the typical box type. I didnt like the prusa and I wanted enclosed.

Over 60% of items have arrived so I am building. Its quite fun the way I have done it. I may do a Ebay group type order and take orders to get better price ect. "alot of people raping or waitibg to rape us believe me."

Arduino uno

Ramps 1.4

A4988 drivers

Arduino uno 2.5 tft with sd

8366 wifi "no idea how to fit aha."

I have tablets about I would like to use as TFT if any one can help please inbox. Same with the current TFT as I have no idea about firmware.

Nema 23, 17 and 14 "Im play with set up."

M8 thread

M6 thread

M6 roller bearings

M8 roller bearings

M8 mounts

M4 x8 and x12

M5 x8, x12 and x20 lenghs

M6 x8, x12, and x20 lenghs

M4 lick washers

Aluminium 2020 braces

V bearings

Normal m4 bearings

Normal 5A end stops

Proximity sensor

1000w hp 80A psu

Anet A8 mosfet board "need advice on cheaper alternatives.

Theres obviously alot more. I have to get 2040 to finish and for mini mill but mot and car crap due so may be a while.

I will update when I can.

Soecial warning.

Only buy your metal online if it is apsolutely necesary. It can be 100x the cost otherwise so be warned.

EXAMPLE

My rods for 1m are £6 each online. 20p each in shop. I got 16 oieces cut and a bag of m4 m5 m6 for £5. Im warning you.

Take care.

Like

Discussions

RX HMP wrote 05/05/2017 at 12:57 point

Any advice on tft? firmware?

What other ways can I build this with less bars thats solid for 3d printing?

This is 500mm square. I wanted to do like a Tronxy X, crane type with 1m 2040 for the Z movement.

Is there any advantage of 2040 over doubling 2020?

Feel free to give opinions bad or good.

I am a newb.

  Are you sure? yes | no