CuraEngine on linux

mmiscool wrote 09/12/2017 at 22:17 1 point

Hello,

I am trying to get cura engine up and running on linux but there is little in the way of documentation.

Is there any one who is an expert who could give me hand?

The main thing I need is to be able to control it though the command line and be able to turn support on / off and vary the infill %.

I also need to retrieve the x,y,z size of the model (To check if it will fit on the print bed) and the amount of filament used.

I have gotten all these thing working with Slic3r but have been unable to crack the cura nut. 

Any help would be appreciated.