0%

0%

pg88channel

PG88 là địa chỉ cá cược uy tín, cam kết mang đến tỷ lệ cược hấp dẫn cùng dịch vụ chuyên nghiệp. Với nền tảng hiện đại,

11 Thoại Ngọc Hầu, Hoà Thanh, Tân Phú, Hồ Chí Minh

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

This user joined on 03/06/2025.

Projects I Like & Follow

Follow for the 'Hacklet' and latest news about hackaday.io

Hackaday.io Project

A computer running BASIC, generating composite video and reading PS/2 keyboard input using a single ATmega microcontroller

Single Chip AVR BASIC Computer V0.3

Hackaday Prize 2019

Blackbox shifts 3D printing towards a multitool manufacturing robot.

Multitool 3D Printer - Blackbox

marc-schmann Marc Schömann

The 2018 Hackaday Prize

Documentation of the 3rd generation of my ultrasonic phased array project. Levitating stuff, directional speaker, haptic feedback and more!

Open Source Ultrasonic Phased Array

lucy-fauth Lucy Fauth

Pavapro is tiny programmer you can bring anywhere. You can load binary file into it and bring/use it as you wish. And a bit more than that.

Pavapro - portable AVR programmer

jaromirsukuba jaromir.sukuba

My attempt to put together a digital clock made of analog clocks, as originally created by Humans since 1982 and David Cox

Clock Clock

Single rotor, "human-safe", selfmade ball-drone with air vanes for position control

The Ball-Drone Project

benjamin-prescher Benjamin Prescher

The 2015 Hackaday Prize

PICkit can be used as a PIC Programmer, Serial to USB converter, Logic Probe, Logic Analyzer, but also as an AVR Programmer for Atmel MCUs

Microchip's PICkit 2 as an Atmel STK500 programmer

Built from the microcontroller up using rs485 and 2 km of CAT6.

My fully custom home automation system

bernard-kerckenaere Bernard Kerckenaere

Syma X5C Drone meets DJI FC40 WiFi 2.4GHz Camera bringing FPV to a cheapest level

Restyled Syma X5C Drone FPV Mod

A low cost bed upgrade that adds a second slave heater to allow the bed to reach 110C and also makes the bed flatter and more rigid.

Monoprice Mini 3D Printer Bed Upgrade

The 2017 Hackaday Prize

DIY DLP 3D Printer based on NanoDLP Software using Raspberry Pi 3 and Trinamic Motor Controller

ADAM DLP 3D Printer

How to get the Onago to, well, fly!

Onagofly Hacking

Design for 3D printed Helmholtz Coil that can be configured for any wire size, number of wraps and magnetic strength

Highly Configurable 3D Printed Helmholtz Coil

IoT Weather station to monitor a room powered by Arduino

IoT Weather station

xylitol Xylitol

Voltmeter Clock

brettoliver brett.oliver

Tiny IOT Solution based on Arduino& SIM808 GPS/GPRS

IOT- SIM808 GPS Tracker Based on Arduino

Use your Wemos motor shield with steppers motors I2C custom slave interface

WEMOS Motor Shield firmware for steppers (I2C)

View all

Bits