UPDATE 5: HW Selection and MVP

A project log for Secure Mesh Async Communication (SMAC)

A low cost communication device, similar to a tablet, this can function without an energy grid or a network infrastructure and is secure.

naim.hilalnaim.hilal 04/20/2016 at 01:251 Comment

April 19, 2016 by Naim Hilal

HW update time! Been working on selecting components for our device. As a general rule of thumb we tried to pick parts that are:

We want to keep the design simple and low cost, while it is easy to build. Unfortunately, these don’t always go together, especially with market trends with phones and wearable devices becoming smaller. The market demand drives the cost of small components down, but they are not hand solderable! So we have to find a good balance for each part.

As for the Minimum Viable Product (MVP), we believe that the user should be able to send and receive text messages. Therefore, we need an input device (touch screen), output (screen), and a mean to send/receive messages (WiFi and RFID). These components are highlighted in yellow in V0.3 of the HW Block Diagram below:

The centre of our design is the ESP8266-ESP12. It is the main processor and WiFi module (USD $2.50), it operates on 3.3V and support SPI and UART. So we wanted to set our system voltage at 3.3V and use SPI for communication (because it’s supported by the screen).

For a screen, we found a 3.5” TFT LCD which comes with a resistive touch panel for a low price (USD $9.63). The screen is powered on 2.8V, which will require a dedicated DC-DC converter. Although it adds complexity and cost, it also offers an easy way to control the backlight of the screen. As for the touch screen controller, the TI TSC2046IPWR (CAD $2.30) can run on 3.3V, hand solderable (16-TSSOP), and uses SPI.

As for the RFID, we couldn’t find something that was low cost and uses SPI. So we opted for the Panasonic MN63Y1210AF (CAD $3.54). It runs on 3.3V and uses UART, which is supported by the ESP8266. As for an antenna, the Taoglas FXR.05.A (CAD $4.10) operates on the same frequency of the NFC chip (13.56MHz). This antenna is for the desktop prototype only, we intent on having the antenna etched on the PCB in the final version.

We chose to focus on the above parts for the desktop prototype. Non essential parts that we looked at/noted:


Karl Koscher wrote 04/26/2016 at 01:35 point

You probably don't need a boost converter. If the battery's voltage is 3.3V, there's probably very little energy left in it. Check out the LiPo discharge curves.

  Are you sure? yes | no