04/16/2018 at 17:14 •
started wiring unit from bottom up.
Connected battery wires
Set rechargeable plug on outside
Connected motor wires
Ran both wires up the unit and taped all wires out of fans way.
Connected top motor wires and connected top motor duct to top of unit.
TEST MODE.... connected battery to both motors and fans spin as designed.
(This unit must be sealed tight)
Far from done still work progress to be made.
Thank you for viewing.
04/15/2018 at 17:03 •
installed Fan Box.
Glue on top
Having slight problems and working on solutions.
Nothing that can't be fixed.
04/15/2018 at 03:40 •
3d printed fan box along with fan.
Assembled all parts and connected tubes.
Next step work on setting rods in place.
04/12/2018 at 17:06 •
All fans have been printed
Working on blade box design.
Running test on motor fans.
04/09/2018 at 14:03 •
Finished printing quadcopter body.
Printed piece by piece.
Project was not perfect had to patch a few holes with hot glue.
Next step redesigning box and 3d printing all fans.
Thank you for viewing..
04/07/2018 at 21:24 •
3D printing Top Duct Vent.
04/07/2018 at 04:02 •
Middle Air Duct Design has been 3d Printed
Minor design flaws have been detected and patched.
04/07/2018 at 01:46 •
3d printing started on Fri, April 6
Printing Quadcopter Middle system air duct design.