A project log for 3D printing an RC airplane

100% PLA 3D Printed aircraft (excluding RC gear)

ttnTTN 05/28/2016 at 19:540 Comments

My original plan was to only print the plane, hang it on the ceiling and feel good while staring at it. RC equipment is costly.

I helped my friend Ben out with his university project by printing parts for me. He had a glider he crashed.. but the RC gear was all still intact. He's seen the plane and wants to return the favor. I think you can see where this is going :-)

Eyecandy below!!

Getting there! Each wing section in the picture there takes about 8 hours to print, and the body parts vary from 3 - 8 hours each. I'm printing each part carefully one by one very slow for best results.

As usual, more updates to come!!

(in between studying of course, so updates may spaced out over time and far in between)