Quantity | Component name | |
1 | × | Particle Photon |
1 | × | Particle Relay Shield |
1 | × | 3D-Printed Component: Main Enclosure Lid |
1 | × | 3D-Printed Component: Sensor Enclosure very custom to my specific smoke alarm circuit board, so this may not work with yours. |
1 | × | 3D-Printed Component: Sensor Enclosure Lid |
1 | × | Residential Smoke Alarm I bought a ‘Kidde Battery Operated Smoke Detector with Ionization Sensor’ |
1 | × | TMP36 Temperature Sensor |
1 | × | Male and Female Spade Electrical Connectors Used to connect to the existing buttons/wiring |
6 | × | M3 Screws I think mine were 7mm long, but the holes are 10mm deep so somewhere in that range. |
1 | × | Wire I’ve begun using 4-wire phone cable for all of my electronics projects due to cost, availability and ease of organization when they’re kept in the insulated sleeve. |
1 | × | Screw Terminals 8 total terminals |
1 | × | PCB Prototype Board Or use a breadboard like I did to start |
1 | × | 3D-Printed Component: Main Enclosure |