• Checking that the parts are here + setting input voltage so I don't forget!

    cprossu • 12/27/2019 at 15:30 • 0 comments

    I unboxed the various layers of the printer, just to make sure I was shipped a printer (and not bricks/rocks/etc), and that all the parts were there.

    When I took a closer look, I noticed the power supply was set to 230V, so I set that to 115V at this time so I would not forget to later on when I build the thing. I created a video of the unboxing so I knew how it went in the box, and I had video of the condition everything was in, and specifically in case anything was missing from the time that the tape was punctured.

    Will post the video when I upload it. and update this entry.