Project Logs

Collapse

• Controller connectivity Issue

  deoscode • 05/21/2023 at 15:41 • 0 comments

  The code is designed to allow wireless controllers to connect after powerup. This seems to work "most" of the time. Occasionally a wired controller is not detected on power up (stays in Connecting... state), but requires a reset before it connects. Needs further investigation.

• Schematic Mod

  deoscode • 05/21/2023 at 15:32 • 1 comment

  This works just as well with a wired controller as it does with a wireless receiver module.

  My wireless receiver died for some reason, hence the switch to wired controller until i get my hands on another one. As a precautionary measure I have introduced a 10Kohm pull up resistor to 3v3 for the incoming DATA line.

  I will update the schematic to reflect this when I get a chance.

• Source Code v1.10 avaialable

  deoscode • 05/21/2023 at 15:22 • 0 comments

  Apologies, I started adding features (such as config menu, preset buttons, snoop mode etc),then life got in the way.

  I have submitted my original source code v1.1 release to github:

  https://github.com/deoscode/Ps2Ptz_GPL
  

• Sept 21

  deoscode • 09/04/2021 at 20:10 • 0 comments

  Seems to be working well.
  

  Finishing off the preset up/down clear/save code.

  Need to tart up code for github.

View all 4 project logs