Build Instructions

Collapse

• 1

  Code Edition

  First, open “File” -> “Examples” -> “AmebaWiFi” -> “WiFiWebServer”

  
  In the sample code, modify the highlighted snippet and enter the required information (ssid, password, key index) required to connect to your WiFi network.

• 2

  Upload and Execution

  Upload the code and press the reset button on Ameba. After connecting to WiFi, Ameba starts to run as server. The IP of the server is shown in the serial monitor, and port is 80.

  
  We connect to the server in a browser, and we can see the data sent from the server.

• 3

  Code Reference

  Use WiFi.begin() to establish WiFi connection.

  https://www.arduino.cc/en/Reference/WiFiBegin
  To get the information of a WiFi connection:
  Use WiFi.SSID() to get SSID of the current connected network.
  https://www.arduino.cc/en/Reference/WiFiSSID
  Use WiFi.RSSI() to get the signal strength of the connection.
  https://www.arduino.cc/en/Reference/WiFiRSSI
  se WiFi.localIP() to get the IP address of Ameba.
  https://www.arduino.cc/en/Reference/WiFiLocalIP
  Use WiFiServer server() to create a server that listens on the specified port.
  https://www.arduino.cc/en/Reference/WiFiServer
  Use server.begin() to tell the server to begin listening for incoming connections.
  https://www.arduino.cc/en/Reference/WiFiServerBegin
  Use server.available() to get a client that is connected to the server and has data available for reading.
  https://www.arduino.cc/en/Reference/WiFiServerAvailable
  Use client.connected to check whether or not the client is connected.
  https://www.arduino.cc/en/Reference/WiFiClientConnected
  Use client.println() to print data followed by a carriage return and newline.
  https://www.arduino.cc/en/Reference/WiFiClientPrintln
  Use client.print() to print data to the server that a client is connected to.
  https://www.arduino.cc/en/Reference/WiFiClientPrint
  Use client.available() to return the number of bytes available for reading.
  https://www.arduino.cc/en/Reference/WiFiClientAvailable
  Use client.read() to read the next byte received from the server the client is connected to.
  https://www.arduino.cc/en/Reference/WiFiClientRead
  Use client.stop() to disconnect from the server the client is connected to.
  https://www.arduino.cc/en/Reference/WiFIClientStop

View all 3 instructions