A project log for RT Soldering pen

Soldering pen for Weller RT tips with OLED display

vlkvlk 12/08/2019 at 19:224 Comments

Otto Winter send me STL files with case design for HW v1.0

Bottom part: Weller-RT6-Holder-Bottom-V1.0.stl

Top part: Weller-RT6-Holder-Top-V1.0.stl


smartroad wrote 02/14/2021 at 17:53 point

Just a quick msg, just tried this on my version (0.3 apparently) and this case doesn't fit as the buttons are on the same side as the display and this is case is for the latter version where the buttons are on the opposite side to the screen :(

  Are you sure? yes | no

vlk wrote 02/15/2021 at 11:20 point

No, it is not for 0.3 and also not without modifications for v1.1

  Are you sure? yes | no

Romain wrote 03/26/2020 at 08:54 point

This is a really nice case! I can send the stl I made for my pen too!

  Are you sure? yes | no

vlk wrote 03/25/2020 at 20:17 point

NOTICE! The case after printing is necessary to clean-up with knife - especially around place where is the display, in other cases you can easily broke the display.

  Are you sure? yes | no