USB to TTL <-> SBC connection

GND <-> GND

+5V<-> VBUS

TDX <-> RXD

RXD <-> TXD

During JTAG configuration Micro-USB cable should be connected to FPGA board connector as shown above.  You can see all the eight LEDs are turned ON after successful configuration using SOF 

We can easily verify the ROM content after successful configuration of FPGA using In-System Memory Content Editor 

We can easily verify the XRAM content after successful configuration of FPGA using In-System Memory Content Editor 

We can see the "MCS-BASIC-52 V1.31" at the end of 8k ROM memory as shown above 

Install TeraTerm or Putty.  Run the application.  Select the COM port and default baud will be 9600.

After hitting the spacebar the following message should appear on the screen.

*MCS-BASIC-52 V1.31*

READY message 

Now we can write any application using BASIC-52