Close

X axis is running

A project log for G-EDM

The G-EDM is an electrical discharge machine that supports sinker EDM, EDM engraving, EDM drilling and Wire EDM operations. #Drahterodieren

gedm-devgedm-dev • 05/19/2023 at 18:04•0 Comments
The X axis is finally running. The small Nema-17 Motor has enough power to drive the axis at all microstep settings. Pulleys and belt are printed.

The ballscrew came without a nuthousing so I printed one. It is bigger and uses 4x pressed in M6 nuts to mount the table.
Previous log

Four axis ESP32 Motion controller PCB

05/14/2023 at 04:33 • 0 comments
Next log

Pulseboard and motion controller from PCBway

05/26/2023 at 03:00 • 0 comments

Discussions

Yes, delete it Cancel