PrintAirPipe - Servo Valve

A project log for PrintAirPipe - Printable air duct system

A 3D printable ventilation pipe system with all kind of different connectors and pipe segments.

fabianFabian 04/21/2024 at 17:050 Comments

The servo valve segment of the #PrintAirPipe system can be used as a controllable valve.

The valve blade is controlled by an MG90 servo. Thanks to the built-in ESP32, the servo can be controlled via WiFi or the touch sensor on the housing. 

The LED shows the states open (green) and closed (red). The firmware is based on #ESPhome and the files are available on my blog

STLs & ESPHome Configuration: