Close

~ updated version of my planed pcb~

A project log for Cable-Cutting-Machine

No more boring and endless cable-cutting-sessions.

Kirschner ChristophKirschner Christoph 04/14/2017 at 18:192 Comments

After good advices from the communtity i spend some time to improve my designe. I hope it is a little bit better this time, but tell me if not.

[By the way orange is at the bottem and yellow is on the top of the PCB.]

Next week i go to a science-camp called ESFZ, in Erlangen, where I`m able to etch my PCB. Can`t wait to get this thing reality!!

Have a nice weekend !!! :)

Discussions

Kirschner Christoph wrote 04/14/2017 at 20:04 point

It's quite a difficult work to do :D thanks for your help!! 

  Are you sure? yes | no

K.C. Lee wrote 04/14/2017 at 19:15 point

Still missed a few spots: 
Upper left corner: Vin 5V, Vin 12V GND connection is on top layer
Lower left corner Arduino header: GND the other side is on bottom layer to the Servo.

Other than that, I think it looks fine.

  Are you sure? yes | no