Kirschner Christoph
After good advices from the communtity i spend some time to improve my designe. I hope it is a little bit better this time, but tell me if not.
[By the way orange is at the bottem and yellow is on the top of the PCB.]
Next week i go to a science-camp called ESFZ, in Erlangen, where I`m able to etch my PCB. Can`t wait to get this thing reality!!
Have a nice weekend !!! :)
Discussions
Become a Hackaday.io Member
Create an account to leave a comment. Already have an account? Log In.
It's quite a difficult work to do :D thanks for your help!!
Are you sure? yes | no
Still missed a few spots:
Upper left corner: Vin 5V, Vin 12V GND connection is on top layer
Lower left corner Arduino header: GND the other side is on bottom layer to the Servo.
Other than that, I think it looks fine.
Are you sure? yes | no