Print the parts with no supports and the following settings unless otherwise instructed. 

Print Resolution: .2 mm 

Infill: 20% 

Perimeters: 3 

Filament: I used PLA 

Colors: Lake Blue, Black, White, Grey

Notes: Print the parts in their default orientation.  I have only provided the 3D model files (3mf) in this project.  I'd be happy to provide Fusion (f3d) or Step files upon request. 

.

To make a 36% Scale Type 30 Reproduction you will need to print the following parts: 

1 - Case (White) - In the default orientation you will need to add supports. 

1 - Front Panel (Lake Blue)

1 - Accessories (Gray) - Includes a rim for the Front Panel (1), locking tabs for the Display (4), and side groove covers for the Case (2)).

1 - Back Panel (Black) - Prints in two parts to facilitate insertion into the Case.

1 - Simple Stand (Black) - Optional.

1 - Wire Holder (Black) - Prints in two parts to allow wire insertion.

1. Push the Rim into the round opening in the Front Panel from the back.  I added a 90 Degree HDMI Adapter to the display electronics so that the cable would extend straight back (green circle)
2. Carefully press the Display into the round slot in the back of the Front Panel and secure it in place with 4 locking tabs (red circles).
3. Attach the USB power and HDMI cables to the display electronics mounted on the back of the Display (Yellow Circle).

1. Place the Accessory groove covers into the slots on the sides of the case lining up the holes at each end. You can hold them in place with 4 M3 x 10 mm bolts partially inserted about 4 mm.
2. Carefully push the Front Cover into the Case from the front as far as it will go with the cables going out the back. 
3. Bolt the Front Panel in place with 2 M3 x 10 mm bolts. Note the bolts are self threading so go easy.

1. Push the two halves of the Back Panel into the Case from the back with the cables coming out the 25 mm hole. Because of the taper it's a little tricky. Take your time.
2. Bolt the Back Panel in place with 2 M3 x 10 mm bolts. Note the bolts are self threading so go easy.

1. Line the USB and HDMI cables along the Wire Holder groves and press the two sides together.
2. Slide the Wire Holder into the 25 mm hole.
3. Secure the Wire Holder in place with 2 M4 x 10 mm bolts.  Note the bolts are self threading so go easy.

1. Slide the two leg pieces into the Simple Stand main body.