So let's build a 6-channel true bypass looper
postscript - 1.55 MB - 10/17/2017 at 03:27
After about an hour and a half of soldering in some very uncomfortable places, it's done. It's tested, it works:
I need to find a paint pen to write 'send' and 'return' on the back, but this thing is buttoned up and velcro is on the bottom. Success.
Edit: I got a paint pen:
Step 1: Acquire aluminum enclosure and a center punch
Step 2 put the template on the box
Step 3 punch some divots into the box
Step 4 Oh yeah tiny little marks
Step 5 Drill! Use a 1/8th inch bit. USE A DRILL PRESS THIS CANNOT BE DONE WITH A HANDHELD DRILL
Step 6 Measure the part
Step 7 Measure your step drill. Meh, a mil oversize is fine.
Step 8 Drill baby drill
Step 9 Woot.