Stickvise_CupHolder_Jaw.stl

Make your Stickvise into a big spring loaded cupholder. This is one jaw, so two will need to be printed.

Standard Tesselated Geometry - 409.46 kB - 08/11/2017 at 18:34

Download

Stickvise_InterlockingV.STL

Interlocking Jaws - My favorite jaws, these hold a PCB as well as any size cylindrical part horizontally (from a small wire to a cable to a 1" diameter motor)

Standard Tesselated Geometry - 114.93 kB - 02/28/2016 at 12:24

Download

Stickvise_VJaw.STL

Jaws with vertical v-grooves for holding cylindrical parts upright

Standard Tesselated Geometry - 264.14 kB - 02/28/2016 at 12:24

Download

Stickvise_Grooved_Jaw.STL

wire grooves everywhere, this jaws is almost obsolete compared to the interlocking jaws, but it uses less printer material

Standard Tesselated Geometry - 177.82 kB - 03/04/2016 at 01:13

Download

Stickvise_TallJaw.STL

Raise the PCB up to acommodate tall components

Standard Tesselated Geometry - 30.94 kB - 02/28/2016 at 12:24

Download

Stickvise_MedJaw.STL

Raise the PCB up to acommodate medium components

Standard Tesselated Geometry - 30.94 kB - 02/28/2016 at 12:24

Download

Stickvise_LowProfileJaw.STL

These are the same as the standard Stickvise jaws

Standard Tesselated Geometry - 30.94 kB - 02/28/2016 at 12:24

Download