Build Instructions

Collapse

• 1

  Step 1

  CLEAN UP YOUR WORKSPACE

  Gather your components

  We will start with the "multivibrator" or "Oscillator" circuit. It supplies an A.C. Waveform to the "T1" transformer. 

  you can make a PCB or just solder the legs together

  It's not a very complex circuit.

  First connect the SOURCE pins together on the mosfets

  This is where the -  (ground) connects to the Power supply

  Then connect the GATE pin on MOSFET 1 to the DRAIN pin on MOSFET 2 using a 220ohm-1kohm resistor

  Then do the opposite Connect the GATE on MOSFET 2 to the DRAIN on MOSFET 1 using a 220ohm-1kohm resistor

  You will be connecting the two outer PRIMARY leads on your "T1" to the drain pins on your mosfets

  the third lead (center lead) on the primary hooks up to the + on the power supply

View all instructions