CLEAN UP YOUR WORKSPACE

Gather your components

We will start with the "multivibrator" or "Oscillator" circuit. It supplies an A.C. Waveform to the "T1" transformer. 

you can make a PCB or just solder the legs together

It's not a very complex circuit.

First connect the SOURCE pins together on the mosfets

This is where the -  (ground) connects to the Power supply

Then connect the GATE pin on MOSFET 1 to the DRAIN pin on MOSFET 2 using a 220ohm-1kohm resistor

Then do the opposite Connect the GATE on MOSFET 2 to the DRAIN on MOSFET 1 using a 220ohm-1kohm resistor

You will be connecting the two outer PRIMARY leads on your "T1" to the drain pins on your mosfets

the third lead (center lead) on the primary hooks up to the + on the power supply