Baruch Even-
1Step 1
Solder a four pin female header to the connect at the bottom of the top board
-
2Step 2
Connect the STLink V2 device to the header
-
3Step 3
Use the windows STVP programmer, verify it is read-out-protected, if not, please save the flash and eeprom
-
4Step 4
Erase the ROP flag
-
5Step 5
Program the image to the flash
-
6Step 6
Set the OPT2 AOF0 flag to enable the alternate function on the timer 1 channel 1 and timer 2 channel 1 for the PWM control
-
7Step 7
You're good to go! Just a warning though, the software at this moment is not ready for actual use... Still working on that.
Power Supply B3603 Alternative Firmware
B3606 is a cheap MCU controlled power supply, I'm reverse engineering it and writing software to add serial port and more features.
Discussions
Become a Hackaday.io Member
Create an account to leave a comment. Already have an account? Log In.
How to remove the Device from protected function and moreover without erasing of stock firmware want to upload the new alternative firmware to this device.
Are you sure? yes | no