Tracing the HDS-5310 Encoder

A project log for THE ROBOT PROJECT

My attempt to revive a research/industrial robotic arm.

rickmellorrickmellor 03/13/2014 at 06:571 Comment

Tonight I pulled out the scopes and power supplies and analyzed the HEDS-5310 single-ended incremental encoders that are used on the extremities of the arm.  There are five wires: Vcc, GND, Chan A, Chan B and Chan I.  I was able to use my Saleae Logic 8 analyzer to confirm the output of the encoder so I know that they work and that I'll be able to process their output.


Adam wrote 11/25/2020 at 22:34 point

Hello, If you need I found the datasheet. I try to drive with arduino a x-ray Gantry with this encode and dc motors. Best regards Adam

  Are you sure? yes | no