Instructions | Hololens Headband Repair Kit

1

Select method of repair: Notch Method or Pin Method

If you wish to repair the band by cutting notches in the side, print the Notch Cutter. If you would rather drill a hole through the band through which you would insert a pin, print the Hole Punch Guide.
2

Cut or drill your broken band

Slide the band into the guide and cut or drill. The photo below shows the notch method so the band must be cut.
3

Print Bracket to match Repair Method

Print with at least 100% infill for maximum sturdiness. Supports may be required for some printers.
4

Slide strap and band into the bracket and snap clasps down

Place Side A in place first. Make sure the notches or pin hole is lined up properly. Then press Side B in place and make sure all four clasps snap together..

Hololens Headband Repair Kit