Known I2C Addresses on Same Bus
To avoid address conflicts, known 7-bit addresses are below. If I2C is utilized on your addon, avoid these.
We recommend exposing I2C-slave address pins via test points or pins/jumpers to allow for reconfiguration in the event of an address conflict. Typically these can be changed by pulling the address pin low or high. Refer to the device's datasheet for further information.
|MR ROBOT BADGE||0x60|
|MR ROBOT BADGE||0xA0 -- Using for Serial EEPROM|
|Mr Blinky Bling||0x42|