Close

PCBs are in

A project log for Breadboard Widgets

A collection of widgets/adapters/breakouts to make prototyping easier/faster

stefan-lochbrunnerStefan Lochbrunner 10/01/2015 at 13:121 Comment

Finally!

A more or less completely soldered panel:


Pretty much upon unpacking them I found an error on the silkscreen of the uUSB breakout that must have occurred when I was panelizing the different boards. The order of the pins is wrong on the top silkscreen, where it's hard to read anyway, but it's correct on the bottom. The individual board file in the repo wasn't affected by this error.

So if you don't mind that mistake you can get one in the DirtyPCBs store or trade with me.

Discussions

Stefan Lochbrunner wrote 10/30/2015 at 14:24 point

I just checked the DirtyPCBs status page for this board and was surprised to see that there have been some orders.

Thanks to everybody who ordered it! :)

  Are you sure? yes | no