Close
0%
0%

5x5 28BYJ-48 Grid

Artistic installation to be presented at the end of March 2018

Similar projects worth following
333 views
0 followers
The challenge was to manage the 25 step motor control (the famous 28BYJ-48) using only one Arduino. I used shift register (74HC595) to recreate the sequence of movements and thus have the ability to stop 1 or more engines without affecting the movement of others. The code and the material were designed to be reused in another context, this first version uses a sequence that was pre-programmed in the micro controller.

Artistic installation to be presented at the end of March 2018

The challenge was to manage the 25 step motor control (the famous 28BYJ-48) using only one Arduino. I used shift register (74HC595) to recreate the sequence of movements and thus have the ability to stop 1 or more engines without affecting the movement of others. The code and the material were designed to be reused in another context, this first version uses a sequence that was pre-programmed in the micro controller.

  • About Dupont cable

    Veronique03/01/2018 at 17:56 0 comments

    I thought I did not have any problems using Dupont cables to make my connectors. Unfortunately they are not all of the same quality which brought me a lot of contact problems throughout the tests. I removed the insulating part of the connectors and tighten the pin with a pair of pliers. I will think twice about it next time I have 6 x 25 wires to manage.

View project log

Enjoy this project?

Share

Discussions

Similar Projects

Does this project spark your interest?

Become a member to follow this project and never miss any updates