Macbook pro touch pad as a replacement for a normal touch pad on a Hackintosh so you do not need special extensions.
The touchpad uses SPI or USB.
Keep the CY8C24794 as this is the convert from SPI to USB.
You will need to connect TPAD_VBUS_EN on the CY8C24794 (pin 4) to 3.3v as that is the voltage the CY8C24794 works on .
I used a LM1117 to power the CY8C24794 at 3.3v , and the 5v straight from USB to power the touchpad electronics and the boost circuit for the actual touch.
I used a part of a damaged Macbook 2012 MB on the back side you will need the circled part only.
I will reduce the piece as much as possible in the future.
The MB was bought as damaged so just make sure you have the proper parts if you plan to do this.
You can use this as a magic trackpad if you want.
The main downside at this point is that the device is not connected to the SMC and will not show up in Preferences to configure the device as a workaround you can use MagicPrefs.