Close

110 / 230 V~ PCB Heated Bed

Back to project overview

Meet the Makertum MK1, a 500W PCB heated bed that runs from mains voltage

Discussions

Roberto Hubner wrote 12/18/2017 at 16:28 point

I have difficult to understand if there is any special configuration in the firmware to use this heated bed. Very nice your tutorial of "how to assembly and mount " but nobody is telling anything about changes on Marlin. Did I just replace the bed?

  Are you sure? yes | no

Nathan wrote 10/08/2016 at 23:03 point

Just an FYI, my Marlin PID settings (when calibrated against 110C with 8 cycles) were:

#define  DEFAULT_bedKp 67.61
  #define  DEFAULT_bedKi 13.23
  #define  DEFAULT_bedKd 86.40

  Are you sure? yes | no