0%

0%

sy2002

From retro Adventure Vision to FPGAs, from 3D printed handheld game console TeleBall to AI. I hack and tinker for fun.

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

This user joined on 04/22/2019.

My Projects

QNICE-FPGA is an Open Source 16-bit computer system built as a fully-fledged System-on-a-Chip in portable VHDL on a FPGA.

QNICE-FPGA

TeleBall is an Arduino based retro handheld game console. Play BreakOut single-player and Tennis-for-Two multi-player via built-in radio.

TeleBall - Retro Handheld Game Console

Projects I Like & Follow

The 2018 Hackaday Prize

A smaller and cheaper open source brushless motor

PCB Motor

Getting Marlin to run on the Monoprice Mini/Malyan M200.

Monoprice Mini Marlin 2.0 Support

I rebuilt my Passap E6000 knitting machine so that I can now control not only the front but also the rear needle bed.

Passap E6000 rebuilt and replaced console

Is there room for another oscilloscope? Real Time nodejs/html5 Sci ToolBox! Arduino | Raspberry Pi | FPGA

GinScope | Science ToolBox | Oscilloscope

Gintaras Valatka

3 attempts to build simple and cheap waterproof ROV cameras

Simple ROV waterproof cameras

Add a second brain to your Arduino Mega

RetroShield for Arduino Mega

This project uses 3D printing and a little lathe work to adapt an existing DIY RC aircraft create a Vertical Take-off and Landing craft

Tilt Rotor VTOL RC aircraft

Tiny IOT Solution based on Arduino& SIM808 GPS/GPRS

IOT- SIM808 GPS Tracker Based on Arduino

The 2017 Hackaday Prize

Datalogger WIFI and Bluetooth for the IOT product

IOT Datalogger

Augmented Reality Business Card.

Augmented Reality Business Card

Hardware Hacking of Accu-Chek Performa Insight

Hardware Hacking of Accu-Chek Performa Insight

EthicalHacker523

A 140MHz - 3GHz 2-port T/R VNA and software

Low cost open hardware VNA

Cary W. Cary W.

The 2016 Hackaday Prize

The goal of this project is to create a standardized outdoor robotics platform, similar to the Turtlebot.

Open Rover

I'm attempting to recycle my household plastic into usable 3D printer filament

Recycling Household Plastic for 3D printing

Security alarm based on NE555 timer and logic gates, made for hobby purpose

Security alarm

Andrea De Napoli

The 2018 Hackaday Prize

An open source modular system for learning, development and games.

DevBoy

Nicolai Shlapunov

Successfully authenticate IBM Watson IoT Cloud with the STMicro Nucleo with MEMS gyro, accelerometer, magnetometer, temp, pressure sensors.

IBM Watson IoT Cloud Authentication w STM32 Nucleo

Hackaday Prize 2019

Open Sourcing a Head Mount Wearable Headphone design as an all purpose platform for AR/VR/Audiology

An Open Source Head Wearable Platform

View all

Bits