How to Use Buzzer HW-508 with skiiiD

A tutorial to develop Buzzer HW-508(applicable for KY-006) via skiiiD

Similar projects worth following
This project is an instruction of "how to use Buzzer HW-508(applicable for KY-006) with Arduino via skiiiD

Before start, there is a basic tutorial for how to use skiiiD

We are working on components and boards libraries.

Feel free to use it and welcome to feedback. Below is contact methods




or visit and go to Need help tab.

Comments are fine too!

  • 1 × HW-508(applicalbe for KY-006) Passive Buzzer
  • 1 × Arduino UNO / Nano / Mega
  • 1 × skiiiD Editor

  • 1
    Video Instruction
  • 2
    Step 1. Launch skiiiD and select Arduino UNO
    skiiiD Home

    #1 Launch skiiiD and select New button

    Select Board

    #2 Select ① Arduino Uno and then click ② OK button

    *This is Tutorial, and we use Arduino UNO. Other boards(Mega, Nano) have same process.

  • 3
    Step 2. Add Component
    skiiiD Code Editor Page

    #1 Click '+' (Add Component Button) to search and select the component.

    Search DotMatrix

    #2 ① Type 'Buzzer' on the search bar or find the Buzzer module on the list.

    Searched Result

    #3  Select Buzzer

    Pin Indication and Configuration

    #4 then you can see ③ pin indication. (You can configure it.)

    *This module has 2 pins to connect

    skiiiD Editor automatically indicate pin setting *configuration available

    [Default Pin Indication for HW-508 (or KY-006) Passive Buzzer] in case of Arduino UNO

    Signal: 3

    NC: NONE (Don't have to connect)

    GND: GND

    #5 After configuring pins ④ click ADD button on the right below side

    skiiiD Code Editing Page

    #6  Added Module has appeared on the right panel

View all 4 instructions

Enjoy this project?



Similar Projects

Does this project spark your interest?

Become a member to follow this project and never miss any updates