new part(s)

A project log for R8-D8 - a distant relative of R2-D2

a 12cm radius, 3d printed R2-D2 with some motors, servos and blinky stuff that follows lines, persons or just drives around via bluetooth

davedarkodavedarko 01/20/2015 at 21:170 Comments

With all the hassle with the firmware and recalibration of the zortrax done, I'm finally printing new parts. I had to reprint the 2nd wall again, that I was previously clamping down while printing. The leg holders where 2mm too short, so I had to tweak them and reprint them, too. In general I'm missing some connection points for future parts in my designs, I think I can work with acetone welding at one point but surely like screws and nuts more.