Hardware setup expects an Arduino Micro with the following hardware attached:Big Dome Button hacked to support RGB LED, microswitch normally open pin connected to pin 12, Common Anode RGB pins connected to PWM pins 9, 10 and 11.RGB Illuminated Rotary...
I needed to remove the dials and the switch from the board because I wanted to have them accessible from the rim of the ear muff. However, each of these components had a minimum of 5 pins. My approach was to use a hot air gun to melt all the solder on...
I needed to remove the dials and the switch from the board because I wanted to have them accessible from the rim of the ear muff. However, each of these components had a minimum of 5 pins. My approach was to use a hot air gun to melt all the solder on...
Hardware used. Seeeduino v1.1 Phaktor bought this a few years back, played with it a couple of times but it just sat in his hobby bin ‘til now. Parallax LCD http://www.digikey.com/product-detail/en/27977/27... bought from RadioShack...
Heres how to make it :Unscrew the back off the laser pen.Remove the cap off the ink pen and cut the tip off about the height of the three batteries from the laser pen .Drill a hole in the tip of the ink pen cap and drill two holes through the back of...
Residency0x03FieldKitFieldKit is an open-source software and hardware platform (environmental sensors, app, and FieldKit.org website) that allows individuals and organizations to collect and share field-based research data, and to tell stories through...
This project is currently GPLv3 licensed.You just type voicecommand -e to edit the configuration file and add any speech and the coinciding command. You can see all of the little nifty commands it can recognize just with my config file in the video....
Interactive Disk SpinThe Interactive Disk Spin was born one fateful night when Paul took the cover off an old hard drive, started compulsively spinning the shiny platters with his finger, and then wondered "how fast am I really making it go?" Two late-night...
The Smart Poi: uses the accelerometer in many ways. One way is to translate the sensor data into RGB LED values, printing the colors into corresponding points in the rotational arc. Wirelessly the accelerometer data is transmitted to a computer using...
Currently this bad boy has two modes: hit and hold. Hit turns on the heat until the set temperature is hit, then shuts off. Hold tries to hold the temperature at the setpoint.It also has a FTDI USB to UART IC, so it can be loaded with optiboot (after...
HydraBus v1.0 Rev1.5 In Stock on DigiKey:https://www.digikey.com/en/products/detail/benjamin-vernoux/hydrabus-v1/15652912 Features of the HydraBus board: Very small board only 60mm x 37mm size (extensible with shield which can be connected on top or...
A bendulum is topped with a weight. If you give the top a push, it sways back and forth periodically. The motion is much like a pendulum, except that instead of swinging rigidly from a pivot and moving the most at the bottom, the bendulum’s stem flexes...
I bought an XMS amplifier from a friend years ago and although it was serving it's purpose I got quite frustrated with having to toggle the loudness feature every time the input was changed. This was the beginning of what has now become my network enabled...
IntroductionVaporization is done by off-the-shelf ultrasonic atomizers, either really cheap ones (the black ones in the picture below, 2.50 $ each) or some more rigid ones (the silver one, a Fogstar 300, 290 € each), air is moved by an array of...
Design choices:-ATmega 328 μController + DS1307-Supertex HV5812-IN-12 Russian Nixie Tubes-Use of reed switches to allow control while not having buttons showing