Close

24373 Results for "《〈 문의 OIO↗5793↗7458 》〉강남유흥㉯강남더킹dread강남초원의집강남초원의집강남유흥wheel 강남더킹ㅹブ강남룸especially"

  • FPGA Simulates Analog Computer

  • The general approach using DDAs will be to simulate a system of first-order differential equations, which can be nonlinear. Analog computers use operational amplifiers to do mathematical integration. We will use digital summers and registers. For any...
  • CUBEX

  • CUBEX is capable of the following:- GPS flight mode acquisition - Position reporting using radio (70cm band) - RTTY, DominoEX, THOR- Image data downlink- Power management Unit: Solar charging / Lipo / Low voltage cutoff
  • Single vessel homebrew system

  • Based around an atmega32, the control board will control a solid state relay connected to a 2Kw heater inside my mash tun. The controller will also be connected to a pump that circulates the mash all the time. A ds18b20 is used to read the temperature...
  • Infrared serial link for AVR

  • Full documentation at http://people.ece.cornell.edu/land/courses/ece4760...The receiver circuit is shown in the picture. The RC circuit acts a low-pass filter on the power to surpress spike noise and improve receiver performance. The RC circuit should...
  • piculear

  • piculearThis incomplete but slowly progressing project has the ultimate goal of producing a reliable PIC ICSP programmer that just works and can be more readily picked apart, examined, and/or replaced than a comparable Microchip programmer (for instance,...
  • SonoMKR Noise Monitoring

  • Features Capture audio input from 1 or 2 channels (configurable)Calculate the noise level, in dB, from every channel, in thrid octave bands plus the LAeq level in dB(A), every second.Write the measured noise levels in a CSV file (file duration is configurable).Send...
  • Airsoft RC-XD

  • is a fully functioning airsoft RC-XD . For the video function I used a gopro with a wifi backpack and streamed it to my phone, theres a bit of lag but it is fast enough for my purposes. the detonation works with a garage door opener hooked up to...
  • PCB mill for under $10

  • NOTE: This project is gradually improving. It is fully functional at this point, but it could be better.It started as a pen plotter based on the entrails of a printer. It uses a pen to draw paths from a vector graphics file(SVG file). I wanted to make...
  • Evette

  • I bought this Vette from a friend incredibly cheap, and to be "nice", it needs a few external parts and paint job which I'll be adding after modding. I have various ideas for what capabilities to add to this car. I comes to mind that since I'm not 20,...
  • Hexapod

  • The general idea is to use the PI and camera to perform the inverse kinematic equations and to perform obstacle avoidance, this information is passed onto the servotor32 board to set the servo positions according to the IK equations. Everything will...