Ok I pored the cement in the tube with a blue foam board on the bottom glued to the sides. That seemed to work out well accept I stuck a blue foam board cutout with a hole cut out in it to keep the 2" pvc pipe in place. Bad Idea it moved the PVC pipe...
Building the blind minder breakout board:For this one, I think I'm just going to give a picture, a sketch, and the STL files. It's so simple it's not even really worth a full build log.Clockwise from the top left, the outbound pairs are:9V brick (for...
Receiver:This end is connected to mains voltage (240VAC for me). Ignore the photos as that was done on old board with other projects, and still used ATmega's. Line up a 7805 or your favourite regulator and feed the uC and RF module. Grab a data line...
The speaker was re-purposed from an old Motorola hands-free set. It is a unit with a housing that included a decent speaker, power ccts, and amplification. A coiled cord ran out one end to an auto lighter adapter and a second coiled cord ran to a jack...
Launchpad-Mame-Control TI Tiva C Launchpad firmware for Mame USB arcade controls adapterThis project is intended to design firmware for the TI Tiva C Launchpad development board to enable it to be used as a USB gamepad/mouse adapter for arcade and other...
What we're doing is exploring the data rate limitations of glass by streaming high quality video to the heads up display(HUD) while sending orientation data to the Beaglebone. Both the video data streaming from the camera through the Beaglebone and the...
Connect driver boards with ribbon cables. 7-segment display boards and led board uses 10 wire cable, 14-segment displays use 12 wire cables.Note that there is no 12 wire IDC plug, so I used 14 wire plug and left the last two wires unconnected on the...
Next I would suggest hooking up the Reed Switches (open and closed sensors) and WeMo to the Arduino board and loading up the code and testing the logic. Feel free to add some serial.println commands to view the state of the FSM, compare that to...
Print the shell. We obtained the original design from Thingiverse and then removed material from the back to mount the Bluetooth device and microphone. The current version can be found on github at https://github.com/TampaHackerspace/3D-Print-and-Model/tree/master/STNG%20CommunicatorWe...
Assemble the badgebundle your wiring and place it into your 3D printed shell. Note that you might need to dremel the back of the 3D printed shell in order to adjust it make it snug.Test to make sure you have communication, then use a glue gun to set...