The wind sensors, Arduino and EMT conduit telescoping mounting pole took measurements outdoors for about 90 seconds. The raw data, and processed wind speed and wind direction data are presented below. The method for converting from the raw Arduino readings...
This is the code I used for the right frame in the first picture.#!/usr/bin/perl#use CGI qw/:standard/;use URI::Escape;my $cols = 3;my %button_codes;$button_codes{'1'}='BTN_1';$button_codes{'2'}='BTN_2';$button_codes{'3'}='BTN_3';$button_codes{'4'}='BTN_4';$button_codes{'5'}='BTN_5';$button_codes{'6'}='BTN_6';$button_codes{'7'}='BTN_7';$button_codes{'8'}='BTN_8';$button_codes{'9'}='BTN_9';$button_codes{'0'}='BTN_0';$button_codes{'Ch-'}='KEY_CHANNELDOWN';$button_codes{'Ch+'}='KEY_CHANNELUP';if...
And this is the left frame. flowplayer href="http://xxx.xxxxxx.org:8080/stream.flv" style="display:block;width:320px;height:240px" id="player"> flowplayer("player", "flowplayer-3.2.11.swf");
Disassemble the primary unit of the video glasses, which now resembles a black plastic bar. You should end up with two boards connected by a thin-film ribbon cable, one of which is connected to another board (containing a USB-like plug) connected by...
Disassemble the primary unit of the video glasses, which now resembles a black plastic bar. You should end up with two boards connected by a thin-film ribbon cable, one of which is connected to another board (containing a USB-like plug) connected by...
Step 10 - You will likely want to mount some kind of USB extension connector through the back of the frame. Again, the type and style will depend on your control adapter, and if you've made it this far, you should be able to figure that out on...
Step 11 - Mount the hardboard bottom to your frame to enclose the electronics and wiring, and mount the feet so it doesn't scratch the hell out of your coffee table.
Analog 5 is the ambient light sensor. It outputs an analog voltage that is proportional to the amount of light it is exposed to.I mounted it inside the glasses frame.
A working Arduino sketch bases on the above wiring can be downloaded here.At startup/reset the glasses will blink dark once.You have a few seconds to change configuration (not remembered between power cycles). Hit the button a number of times...
To install, mount the Reed switches to the frame of the garage door and one of the magnets (that comes with the reed switches) to the door itself such that when the door is open it trips one switch and closed trips the other. Use a multimeter to measure...
The next step should have been attach face. But problems with flight weight caused the copter frame to be abandoned. In its place a monstrosity of balsa wood and disappointment.