Close

3515 Results for "《〈 문의 OIO↗5793↗7458 》〉 선릉셔츠룸㉢ ㈊blankΓ셔츠룸추천셔츠룸℡few 선릉셔츠룸셔츠룸 선릉셔츠룸œ셔츠룸추천Яsupper┤"

  • FlexReplicator
  • Instructions     from FlexReplicator
  • Fabricate the few plastic components by 3D printing. Note these some are intentionally plastic for dampening, and should not be replaced with metal equivalents.

  • NeuroBytes
  • Instructions     from NeuroBytes
  • Try building a few neural circuits!Starter ideas:Basic ring oscillator: 5 NeuroBytes in a continuous loop.Self-extinguishing loop.Randomly connected NeuroBytes that do crazy things (you'll want some Axon Terminals to do this well).Once you get a few...

  • Portable LED Floodlight
  • Instructions     from Portable LED Floodlight
  • Wire up the business end too. A few extra zipties to keep tension strain off the crimp connections.The lights included some stainless brackets and hardware. The light to pole interface I had to get creative.. a few 90º brackets and a hose clamp...

  • Prepare the material
  • Instructions     from Electrostatic actuator
  • First you will need to find a few component to replicate this experiment.you need a soldering iron, some solder, a few centimeters of wire, a High Voltage DC power source (DC Boost sold as taser module). some glue, a bottle of oil, a bunch of plastic...

  • Acquire a few standard power strips
  • Instructions     from Fancy Power Strip
  • I got few power strips from Home Depot. It's really difficult to tell if there's enough room inside before you open them up so you might need to experiment with few models (but at least make sure they're wider than a single module, i.e. 30mm, which almost...

  • Third base
  • Instructions     from Resistor Color Code Clock (v1.0)
  • The final base was built in layers from a quarter inch thick by two inch wide poplar strip. This time, the LEDs are just a few tenths of an inch below the resistor and there is space to conceal the power connector. Twenty-some coats of spray lacquer...

  • Painted Parts:
  • Instructions     from Restoring a 1920's Gramophone
  • On this model there was also a few parts that were painted like the back hinge, the handle and the needle holder. I took some fine steelwool and buffed all of the parts before painting them with some matt black paint using an airbrush.

  • Extrude and Slice
  • Instructions     from 3D fix a helicopter
  • Experiment a few times with different fillings and different layer heights according to your design. If the layer height is too low just because you need a higher resolution, this will not work for small printed volumes unless you have a good cooling...

  • Circuit board
  • Instructions     from Variometer Audio-Only for Hang Gliding
  • The circuit can be constructed on good quality strip board (.1" pitch) and requires only a few tracks to be cut and some larger holes drilled depending on the slide switch available.  Track cutting is easy using a sharp 5mm twist drill in your fingers...
Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday