In order to add wireless access point capability to your media server, you need to install hostapd (hostapd_8192cu from AUR if your wifi dongle is based on a rtl8192cu chipset) and dhcp. If you have installed yaourt as stated in an upper Build Instruction,...
1. The first thing I did after coming up with the idea is to find a way to control 3 sets of 8 leds on each with a minimum amount of wires. I found an article that talked about shift registers and went ahead and ordered a few to try them out. following...
Build Payload MPDB:1) 3D printed parts needed 1x MPDB 1a1x MPDB 1b1x MPDB 21) Cut Material: Cut 1" tubing to 212mmCut 3/8" tubing to 130mmCut 3/8" tubing to 30mm2) Construct Take 30 mm section of 3/8" tubing and place it into the center hole in...
Greetings fellow Enthusiasts Let me introduce myself. I'm Bones MacGyver. I like to make sparks.I'm going to do my best to help out the community with their battery woes.By no means am I a battery expert. But I have used and abused MANY Ni-Cd cells (and...
Winding the inductors is easier than you might think! I used about 4 feet of 18GA Magnet wire to wind the inductors for this particular power supply. Each inductor has ~30 turns on it for an inductance of about 90uH. If you don't have...
In this step, how the Arduino shield stack gets assembled, and how to wire your wave shield will be discussed. If you remember the note from the top in step 1, You hopefully used stacking headers to build your wave shield. If you didn't,...
Cannon code- #include "Servo.h" // include the servo library Servo armServo; // servo to raise the arm Servo cannonServo; // servo to recoil cannon // these constants won't change: const int triggerSensor = 1; // the sensor is connected to analog pin...