Type in http://192.168.7.2:4000/ to fire up the BeagleLogic web interface. If over a LAN connection, this IP address may differ but the port number is 4000 for the web interface.
USB power cable preparationI used a cable from old mouse, but you can any usb type cable (miniUSB, microUSB doesn't matter). Usb is only for power from any usb port. I used phone charger which cost me $1 ;-)
Run Client and Connect to Host• In Terminal navigate to the folder where the client exe is located (not the installer):cd ~/.wine/drive_c/"Program Files"/VMware/Infrastructure/"Virtual Infrastructure Client"/Launcher/• Then run the Client with this command:wine...
Create a Startup Script• Open "Text Edit" on mac or "Geddit" on linux.• Copy and paste the following code into the text document.#!/bin/bash echo "Starting vSphere Client" wine ~/.wine/drive_c/Program\ Files/VMware/Infrastructure/Virtual\ Infrastructure\...
Finding out if the TOPSwitch II on an Ansmann charger (or similar) needs replacement can be tricky; the suggested test bench for determining if it works isn't readily available, and there doesn't seem to be any sources on simple checks that could be...
Power down your Arduino before you connect the medical tricorder shield to it. The USB type B port is really a minus development of the Arduino Mega regarding shields, because the blank USB type B port can cause short circuits or other interferences...
First of all you will need to setup a webserver on your Raspberry Pi, along with PHP. I recommend readinghttp://www.instructables.com/id/Raspberry-Pi-Web-Server/At this point I am assuming that you have followed the above instructable and know the basics...
Next we will install the MPEG-Streamer. Mpeg streamer is a one stop solutionto stream your camera video on internet (Credits: I referred this link to learn how to install it)Open a terminal window and type the following command$sudo apt-get install libjpeg8-devOnce...
Next we will need to do a bit of programming for the Pi to interface smoothly between the Pi cam and the webpage. We will be passing some values to a python file from the PHP instructions to trigger the GPIO pins on the Pi (before you do this however,...
Alternative SubPos Node ConfigIf you have a SubPos Node, plug the Node in via USB and open a terminal application with any baud rate settings. Type help to show the menu and type wizz to use the wizard config. Follow the prompts to configure the Node...
I just did not have the time to draw this out on fritz, so i went old school. I also added the prices i paid for each item. just to give you an idea of the cost of the project.Key/LegendSignal Lines: The green lines are all signal wires that hook up...
Connect your K-type Thermocouple to the amplifier1. You will need your small screwdriver for this step2. Unscrew the positive and negative terminals on the amplifier.3. Place the yellow wire of the K-Type Thermocouple in the positive terminal. Also place...
Setting up Arduino and Python code:The overall schematic for software control can be seen below:ARDUINO:To setup the arduino, the user needs to download the code from the Github repository. Go to the master branch and download the fly_pi_development...
First step to build Jeremy is to purchase all the materials. You will need the followingElectronics:X1 Adafruit Wave shield (https://www.adafruit.com/product/94)X1 Arduino Mega (https://store.arduino.cc/usa/arduino-mega-2560-rev3) (note: any Arduino...
Register the Installation OnlineYou must register your installation for it to appear in PocketPark on an iOS device. Once configured, a backend service tells the iOS device how to discover your installation using Bluetooth Low Energy and iBeacons.To...