Close

27106 Results for "《 예약문의 OIO↗8489↗8306》선릉레깅스┛Еimportanceム강남레깅스룸레깅스룸ㅂheavenly 레깅스룸강남레깅스 강남레깅스룸⊥선릉레깅스ゥfiercelyり"

  • The supports/bearings
  • Instructions     from Projector Screen
  • Drill two holes, almost all the way through, two blocks of something the same size as the outer diameter of your roller blade bearings. It's a common size like 3/4 or 7/8in. Make them identical. For the hole you are after, you need a nut on the threaded...

  • The motor
  • Instructions     from Projector Screen
  • Take your other coupler nut, and fashion a small post coming off of it at a 90 degree angle. I welded mine. Take your corner brace, and make a second post behind the first, the thickness of the corner brace, so the main post slides on the front, and...

  • Trimming the screen
  • Instructions     from Projector Screen
  • Run the motor in the 'screen up' direction. Take a brand new, sharp razor knife and hold it against un-even ends of the rolled up fabric. Make sure the direction of travel of the material is going away from you, so the knife does't bind in the cut and...

  • The control circuit
  • Instructions     from Projector Screen
  • The relay coil is driven by 'remote power' output on the projector. There are no other connections made to the coil. As such, this also performs the needed isolation so if you screw up anything else, you at least don't fry your projector. The projector...

  • Final assembly
  • Instructions     from Projector Screen
  • Put it up on the wall and level it.  One day in the sun will remove any wrinkles, or careful application of a hair dryer will do the same.  Don't overheat it as the plastic inside can expand and ruin it.Tweak the stop positions.  Applying...

  • LED Hoodie
  • Instructions     from LED Hoodie
  • Sew the gemma onto the hoodie in a location that is relatively close to where you are putting the leds.I put it on the inside of the left half of the hoodie.Make sure you read adafruit's guide on sewing with conductive thread, especially the part about...

  • LED Hoodie
  • Instructions     from LED Hoodie
  • Sew (using non-conductive thread) a small pocket next to the gemma for the batter.  Make it fit your battery, not too big, not too small.

  • LED Hoodie
  • Instructions     from LED Hoodie
  • Sew the leds, one at a time, connecting power, gnd and pin D0 from the gemma
Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday