Check out the dropbox link in the side bar for ALL the files & instructions to build the project!https://www.dropbox.com/sh/vua1qej1wcvduxy/AADoxi9PGJf8n_nRHCfp4V_na?dl=0
Cut the first piece of woodCut a 60 to 80mm long piece of the first bar of wood (the 35x50mm one), the cut it at 45° across the middle of the 35x60mm side
Arduino D2-D11 to lins 1-10 on the LED bar graph. 220 ohm resistors from opposite side of graph to ground.Fuel level sender Grn/Blk to 5V and Gry/Blk to Analog 0 with 10k to GNDLow fuel LED to Digital 12 with 220 ohm resistor
The vise-action side of the clamp would protrude in the front of the machine attached to the wooden brace in front by two small bolts run through two small holes easily drilled in the aluminum bar clamp base.
Installing the extEEPROM LibraryThe extEEPROM library is installed using the Arduino Library Manager, from the top menu bar : Sketch -> Include Library -> Manage Libraries -> extEEPROM
Solder the wires from the sensor bar to the Teensy according to the schematics diagram. Power bus positive goes to 3V and negative goes to AGND. Some pins are pads on the back. No worries. Just pre-tin pads and wires, then solder them both together.
In step six you are going to launch the "Talker" app in Raspberry Pi's chromium browser. Open a new window for browsing the Internet and type http://127.0.0.1:8000in the URL address bar. The "Talker" app should now be running locally on the raspberry...
From the rods, i have cut several pieces: From the squared rod, 4 pieces that are 8 cm longFrom the rectangular, 2 pieces that are 10 cm long From the round, 2 pieces 22 cm longFrom the threaded bar, one piece 24 cm long
Put a bit of acetone on both halves, then stick them toghether, and apply pressure for one minute. I found out that if you clamp the pieces with a quick clamp (photo) they stick very well.
Mount the switch and the barrel jack to the box and do the solderings. You know how to do it right?but pay attention: you should disconnect the adaptors and the angle makers from the light bar before starting.
You can find a detailed description of the following steps at https://www.pj rc.com/teensy/loader.html. Connect the teensy board to your computer. Execute the teensy loader application. Push the button of the teensy board. From the File name, choose...
The LCD display will count in 1/100th seconds when the IR beam is broken. When the beam resumes, the count will stop. After a period of 3 seconds, the beam can be broken again to restart the time, or the push button can be pressed to save the current...
During the download the progress bar is blue. After a successful download the progress bar becomes green and you can close the STM32 Flasher Loader. Remember to disconnect the USB-to-Serial Converter and bring BOOT0 again to the 0 position using the...