De forma paralela a la banda, alejado con respecto a su centro y el borde de la banda a 80 [mm] y con sus perforaciones traseras en línea con la de fijación de la banda.
In the GCODE for the first position, write this: G0 X Y F9000 ; Go to position And in the GCODE for the second position, write this: G0 X Y F4000 ; Press the buttonG0 X Y F4000 ; Release the buttonReplace the ,, and the from coordinates from step...
We have two modules suitably resized to be used as axi X (red) and axis Y (blue). We needed this two similar structures, and placed it in orthogonal form, that is, his axes displaced 90 degrees one respect the other. In this image we see how we must...
Take the analog stick and solder the appropriate wires to it. Place ground to ground, 5v to 5v, x to A4, and y to A5. Again do not use male ends to the arduino.
[ ] Install a jumper sideways over RP2 from STEP A to the pin NOT directly on the other side of RP2, but one place over, towards the Y jumper you just installed. See right bubble in picture.
Connect your BUS MOUSE pins to the following pins of your Arduino Pro Micro:Gnd : GroundVcc : Vcc (+5V)Port D3 : X axis encoder / channel APort D2 : X axis encoder / channel BPort D1 : Y axis encoder / channel APort D0 : Y axis encoder / channel BPort...
Finally screw the spacer onto the joystick breakout boardSolder the joystick onto the perfboard and connect VCC (5v) and GNDConnect the X pot to A1 (Since the board is rotated X becomes Y)Connect the Y pot to A0Key is not connected
The chassis is finished and the drive / steering mechanism can be tested. The chassis sides have the massive slot as shown in the photo above and this is for the CNC Y axis to run inside, so increasing the effective travel of the Y axis by 100 mm.
- The CNC Shield axes used for this project are X and Y. - Set all of the microstepping mode jumpers (microstepping = 1/16) for both X and Y drivers- Attach the shield onto the Arduino- Attach the stepper drivers the correct axes locations on the...
Using the M5 screws and nuts, join together the Nut thread box and the Thread box cover, and then attach this assemble to the railsUtilizando los pernos y tuercas M5, unir la caja de la tuerca del hilo con la caja que cubre el hilo, y luego unir este...