Right after the assembly, a basic test confirms the modules work, though the pulse generator frequency is somewhat off. Replacing a 6.8 kΩ resistor with a 4.7 kΩ should fix this. When one module is fed with the 1 kHz signal (from the oscilloscope reference...
READ THIS:● Some of you guys on the community commented that the AC high voltage clearance is too low. YES, YOU ARE RIGHT! I usuall add copper plane to all my PCBs and that was a mistake made ina hurry. So even if you see a bad clearance in the...
Now that we were getting out of the concept realm and into the real world tangible stuff, my anxieties began to relieve a bit. It was time to take some measurements ! I rolled over to the nearest bus stop, and took out my midnight measuring tape...
The big hacker day was upon us and the gears were in motion! Julia jumped into action during morning solo hacker time. She went to the Mission Fabric Outlet store to find our throne-worthy textiles, as well as coordinating with a participant...
Julia and I rushed over to TAP plastics, hoping to get our acrylic sheet before closing. On the car ride over, I opened my CD case and asked Julia, "is there any music thatyou'd like to hear?" "You just have old people music, right?'" she said. She wasn't...
Once we got back to my apartment, the fatigue began to set in. It had been a long day already, with nonstop running around. I asked Julia if she could wait for a few minutes while I rested. She was totally understanding and didn't give me...
The serial port pin-out is cunning designed so that you can connect to a PC with a simple modem cable, or daisy-chained with other TTi devices. 1 Power to optional PC-02 2 TXD Transmitted data from instrument to PC 3 RXD Received data to instrument from...
The first step, after wiping-off the accumulated grime and surface corrosion, was to assess what I have. Within the very large - and very heavy! - case were four cards - an MZB-3 CPU card, a VDU-2K (composite video only) 'graphics' card, an FDC-1 Floppy...
I got this idea based off of a research paper a friend showed me and decided to go full prototyping mode with it!So let's say we have two tapes right, E is our tape with magnets on it, which is slightly longer than D (which has hall sensors). They are...
Initially, I roughly design the device to meet the following points: Slim and smallCellular connectivityGNSS -based location trackingLow-costBattery-powered and Rechargeable Working on the schematics, I was able to achieves those points and choses...
In 5 daysThis is a distraction from writing the Pelicam software but days off and nice weather, have to flyI'm going to at the very least build a crude 1 day thing that functionsIt is pretty much just a battery-powered rpi cam... but it will be attached...
I've started by laying out the five boards in Eagle 9.52. Boards are now being ordered through JLC. All parts have been ordered through Mouser and Digikey - however sourcing a small meter and solar panel that will match have been a bit of...
Well, initial testing was more difficult than expected - took about five hours just to get a couple of basic circuits working. Made a number of incorrect assumptions / mistakes including:Assuming it might be differences between components (germanium...
As the title says, this is a preliminary test of the first version of the multimeter. Before the test, I basically calibrated it using my Fluke 101 as a reference. The results of the test are as follows: 2.5V Error: 0.569, Coeff of Var: 0.0102 5V Error:...