So I spent maybe 2 hours setting up the groundwork of this excel spreadsheet and then maybe 15 minutes actually puttinging in some values. This spreadsheet assumes I'm using #Tetrescent [gd0150] and in a mirrored (aka vertical) mode where for both...
Making the previous changes to the instruction also gives a few extra instructions: ST AC->[X,X] and ST AC->[X++,X++]. These are not super useful, so I decided to make a change to give me ST AC->[X++,D] instead. I can do this by...
So, the newest little module is finishedThis is the state machine module für the LDA X command (load the accu with value X). The next step is to mount this module into the system, connect it and...test it.
After long days of waiting, Delta X, the first open source delta robot kit in the world, is finally launched on Kickstarter. Click on the link to get our discount rewards. https://www.kickstarter.com/…/delta-x-the-first-open-source… Thank you very much!...
Hello friends,We have officially open-source Delta X firmware and 3D printed parts today. The source code for the new software will be uploaded tomorrow. I hope you create many interesting projects from Delta X and make it to be the best open source...
Baffa-X is a project to transform Baffa-2 into a MSX1 Computer. It's based on Brazilian Sharp's HB-8000 (Hotbit) schematics and Beer 202 IDE Board. The projects also uses the original Z80 CPU, 64KB RAM and TMS9918 Boards from Baffa-2. For more information...
Baffa-X (Baffa-2 with MSX Boards) now has a Wifi Modem based on 16550 and Esp32. It's similar to original Baffa-2 SIO Board and compatible to BadCat Card software/terminal.
Baffa-X is a project to turn Baffa-2 into a MSX1 Computer. It's based on Brazilian Sharp's HB-8000 (Hotbit) schematics and Beer 202 IDE Board. The projects also uses original Z80 CPU, 64KB RAM and TMS9918 Boards from Baffa-2 and will be available...
I wanted to control A/C devices, but I didn't want to deal with high voltages. Then I remember X-10 home automation system which according to Wikipedia is 40 years old!? Probably not very practical, but it was fun!
Hey Machine Learners,Exciting news! We ordered our first set of Myriad X parts today, for our initial round of internal development/verification boards.Only 10 units so far, as their just for internal use.And if all goes well, we’ll be able to...
A belt pulley was adapted to the 2.2 kW Spindle motor (China Spindle - used as motor) to drive the spindle cartridgeComponents for the X-Y-table were machined on the latheSide stiffeners for the z column (lasered plates)Assembled Z-axis, side stiffeners...
One improvement I'm making to the Gigatron is to increase the instruction set. I wanted this to be 100% compatible with the original, so that means I can't really replace any instructions that anyone may use; however, there are some instructions...
May 19, 2016I assembled the parts we’ve been printing on the Wanhao for the last couple of days and wired it to the controller, and it’s working pretty well. Check out the video for our makeshift testing setup to see it in action.
Robot 1-X R4The final revision simplifies programming by permitting a total of 6 pin headers or using 2 pogo pins, rather than requiring test clips. The solder mask is purple, matching the original Robot 1-X design. A total of 144 will be making their...